Welcome to Adamov Reglazing, your trusted partner for bathtub reglazing and cabinet refinishing services in Southern California. We proudly serve residential and commercial clients across multiple locations, helping you revitalize your bathrooms and kitchens with cost-effective, professional solutions.
Looking for bathtub reglazing in Upland? Adamov Reglazing restores porcelain, cast iron, fiberglass, and acrylic tubs across Upland and the Inland Empire foothills — ready to use in about 7 hours, backed by a 4-year warranty, with no hidden costs. Reglazing instead of replacing saves thousands of dollars and days of demolition mess.
A lot of Upland’s foothill homes north of Foothill Boulevard still have their original cast iron tubs, and the older neighborhoods around Euclid Avenue have some of the oldest housing in the area. Those tubs are built to a standard you can’t buy now — the iron body lasts generations, and what wears out is the thin porcelain enamel on the surface. That’s a surface problem, and surface problems are fixable in a single visit.
We handle:
The tub on this job was original to an older Upland home and solid as ever, but the surface had aged the usual way: enamel worn thin in spots, a couple of chips, and rust starting to show through where the porcelain had given out.
We stripped and deep-cleaned it to clear the soap film, scale, and grime, then treated the rust and filled the chips, bringing them flush with the surrounding surface — because spraying over a low spot or a corroded patch just leaves it showing through. Once the repairs were smooth, we sanded the whole tub to scuff the old enamel so the coating would bond, which on cast iron is slow, careful work and the part that determines whether the finish lasts. Then fresh caulk, the room masked, ventilation running, and bright white sprayed in even coats.
What came in stained, chipped, and rust-streaked went out looking brand new — but it was still that solid, heat-holding original underneath. The homeowner kept the better tub, skipped a replacement that’s a real hassle in an older bathroom, and paid a fraction of what a new install would have run.
People are often surprised by how the time breaks down. Most of the hours go into the parts nobody ever sees — the stripping, the rust treatment, the filling, the sanding, the masking off — and the spraying itself is the short end of it. That ratio is the whole difference between a reglaze that lasts and one that peels in a year, which is why we don’t rush the front half of the day to get to the spray gun sooner.
We work around your household as much as we can: the bathroom is out of use for the day, the rest of the house stays clean because the room gets fully masked, and our ventilation setup pulls fumes outside rather than letting them drift through the place. Once the finish is on, it needs a stretch to cure before the tub goes back into service, and we’ll give you the exact window rather than a vague wait-a-while — usually the tub is back in use the same evening.
Almost always, yes. Pull an original cast iron tub and you’re swapping a fixture built to last generations for a lighter, thinner modern one that won’t — and in an older foothill home, you’re also losing a tub whose proportions and heft suit the house. Restore the surface instead and you keep all of that, with a finish that looks brand new sitting on a body that’s as solid as the day it was cast.
Every job finishes the same way: we hand over a post-care kit and our cleaning recommendations, so you know exactly how to keep the finish looking sharp. Clean it gently, keep the abrasive powders off it, and the surface holds its shine for years. The work carries a 4-year warranty, so you’re not taking our word for that on faith.
This job was in Upland, and we cover the neighboring cities just as easily — Rancho Cucamonga, Ontario, Montclair, Claremont, and Alta Loma.
If you’re weighing whether to keep your cast iron tub or replace it, send us a few photos and we’ll give you an honest, no-obligation read on it. Call (310) 401-4491 — if refinishing isn’t right for your tub, we’ll tell you that too.
For more information you can check out our Blog or FAQ.
