Welcome to Adamov Reglazing, your trusted partner for bathtub reglazing and cabinet refinishing services in Southern California. We proudly serve residential and commercial clients across multiple locations, helping you revitalize your bathrooms and kitchens with cost-effective, professional solutions.
Looking for bathtub reglazing in Eastvale? Adamov Reglazing restores porcelain, cast iron, fiberglass, and acrylic tubs across Eastvale and the Inland Empire — ready to use in about 7 hours, backed by a 4-year warranty, with no hidden costs. Reglazing instead of replacing saves thousands of dollars and days of demolition mess.
We handle:
Had a porcelain tub come through in Eastvale last week that somebody had painted over at some point, and if you’ve ever seen a painted tub you already know how that story ends. The paint was peeling along the edges, it felt rough where it should’ve felt smooth, and water had been creeping underneath it for who knows how long. The homeowner had been living with it, hoping it would hold. That’s usually when people call us.
The edges are always where these go first, and there’s a reason for it. Paint sits on top of porcelain rather than bonding into it, so the film has a perimeter — and a perimeter is an opening. Water finds it, works under the film, and from there the paint is being lifted from underneath every time the tub gets used. Once it’s loose in one place, the rough patch that’s left collects grime and holds moisture against the surface, so it keeps moving inward. By the time someone calls us, the edges are usually gone and the middle is on its way.
First thing we did was take a good look at what we were actually dealing with. You can’t spray a fresh coating over an old surface and expect it to bond — it’ll just fail again, faster than before. So we started sanding the tub down to knock off the old coating and rough up what was left. This part isn’t glamorous and it takes patience, but it’s the difference between a finish that lasts years and one that flakes off by next spring. We worked through the old paint, pulled off what was loose, and brought it down to a surface the new coating could actually grab onto.
Once the old coating was mostly gone, we moved into a deep cleaning. And we mean deep — every bit of dust, soap scum, body oil, all of it has to come off. Porcelain tub refinishing lives and dies on prep. People think the magic is in the spray, but the spray is the easy part. If the surface underneath isn’t clean and dull and ready, nothing you put on top is going to stick the way it should.
There were a couple of small chips here and there, the kind of thing you stop noticing after you’ve seen it every morning for a few years. We filled and repaired those so the surface would come out level and smooth. Little stuff like that matters. Nobody wants to run their hand along a freshly reglazed tub and feel a divot.
Before any coating goes on, we mask off the whole bathroom. Tub reglazing throws overspray, and that fine mist will find its way onto your walls, your fixtures, your floor, anywhere it can land if you let it. So we tape and cover everything that isn’t the tub. Then we set up our exhaust and blower ventilation — partly for air quality while we’re working, partly to pull the fumes and overspray out of the room instead of letting it settle. It’s a step a lot of folks skip, and you can always tell when they did.
With the room sealed off and the air moving, we laid down the new coating in a bright white. That part’s always satisfying. You spend most of the job on the rough work nobody sees, and then in the final stretch the whole thing transforms in front of you. The tub went from a tired, peeling, patched-up mess to a clean, glossy, bright white finish that looked like it just came out of the showroom. The homeowner loved it — that bright white really woke up the whole bathroom.
Every job finishes the same way: we hand over a post-care kit and our cleaning recommendations, so you know exactly how to keep the finish looking sharp.
This job was in Eastvale, and we cover the neighboring cities just as easily — Corona, Norco, Jurupa Valley, Chino, and Ontario.
If you’ve got a tub that’s seen better days — peeling paint, worn-out finish, chips, the wrong color — call (310) 401-4491. Reglazing costs a fraction of replacement, and done right, it’ll hold up for years. We give honest estimates up front, no pressure, and we’ll tell you straight whether reglazing makes sense for your situation or not.
For more information you check out our Blog or FAQ.
