Welcome to Adamov Reglazing, your trusted partner for bathtub reglazing and cabinet refinishing services in Southern California. We proudly serve residential and commercial clients across multiple locations, helping you revitalize your bathrooms and kitchens with cost-effective, professional solutions.
Twentynine Palms is a desert town, and out here the desert is what wears a bathroom down. The water runs hard, the air is bone dry, and between the two of them a fiberglass shower goes dull and chalky faster than it would just about anywhere else. Add in homes that change hands and take on new tenants fairly often, and you end up with a lot of showers that need freshening before the next family moves in. That’s most of what brings me out this way.
The shower on this job was a between-tenants refresh. The unit was structurally fine — no cracks, nothing failing — but the finish had gone dull, the hard water had left a chalky mineral film worked into the surface, and grime had settled down into the textured floor. The owner wanted it clean and move-in ready, and wanted it done quickly so the place wasn’t sitting empty any longer than it had to.
That’s exactly what refinishing is for. There’s no sense tearing out a working shower and losing weeks to demolition and a new install when the surface can be brought back and put right back into service. Replacing a fiberglass unit means cutting into the surrounding walls, hauling the old shell out, fitting a new one into framing that doesn’t always cooperate, and then repairing everything around it — days of work, a few different trades, and a bathroom out of commission the whole time. Refinishing is one visit, done in place, with the rest of the room left exactly as it was.
I cleaned the surface down hard first, brushing the dirt out of the anti-slip pattern in the floor and clearing the chalky mineral film that scrubbing alone won’t lift. Then a light sanding took the dull, etched layer down to a sound base so the coating had something to bond to. Old caulk out, fresh caulk in to seal the seams watertight, the bathroom masked off, ventilation running, the fiberglass primed, and several coats of bright white on top.
The shower came out looking brand new — bright, smooth, and clean, the kind of thing that shows well the moment someone walks through the door. And because the whole job wrapped in a single day, the place wasn’t off the market long.
For a rental, that durability matters as much as the look, and it’s worth being plain about why it lasts. A real refinish is a bonded coating over a stripped, sanded, primed surface, not a cosmetic coat that tires after the first tenant. The smooth, sealed finish also gives the hard water far less to grab onto than the worn original did, so it stays looking sharp through the kind of use a rental sees rather than clouding over again in a season.
Keeping it that way out here is mostly about staying ahead of the water — a wipe-down after use, a gentle cleaner, and the harsh abrasive powders left in the cupboard, since those wear on any finish over time. Do that and the bright white holds its shine for years, which is a long way from where the original fiberglass ends up in this climate.
On timing, the finish dries in roughly seven hours, so in most cases the shower is usable again the same day rather than sitting out of service while you wait. The work is backed by a four-year warranty as well, so you’re not gambling on how it holds up. If you’re working around a move-out date, tell me your window and I’ll plan the visit around it.
I refinish showers across Twentynine Palms and the surrounding desert, and throughout Orange County, San Bernardino, and Riverside. Whether a tired shower is holding up a turnover or just dragging down your own bathroom, send me a few photos and I’ll give you a straight, no-obligation read on it. My estimates are honest — if refinishing isn’t worth doing on your unit, I’ll tell you.
