Welcome to Adamov Reglazing, your trusted partner for bathtub reglazing and cabinet refinishing services in Southern California. We proudly serve residential and commercial clients across multiple locations, helping you revitalize your bathrooms and kitchens with cost-effective, professional solutions.
The homeowner in Colton had already gotten a quote to rip the tub out before they called me. New tub, haul-away, the plumbing, the tile work to close it all back up — the number was steep, and the tub they wanted to throw away was a heavy old cast iron one that, honestly, was built better than anything that would have replaced it. That’s the part people miss. The iron body on those old tubs lasts the better part of a century. What wears out is the thin layer of porcelain enamel on top, and that’s a surface problem, not a tub problem.
On this one the surface had a rust ring creeping out from around the drain and a chip near the rim where something heavy had been dropped years back. The enamel had also gone flat and chalky from decades of use. None of that means the tub is finished. It means the tub needs reglazing.
I started by stripping the surface down and giving it a hard cleaning to clear the soap scum and mineral scale that builds up over the years. Then I dealt with the rust and the chip. The corroded spot got treated and the chip got filled and brought level with the surrounding surface, because if you spray straight over a low spot the new finish just sinks into it and the flaw telegraphs right through. Once those repairs were smooth, I sanded the whole tub to take the slick off the old enamel — that scuff is what gives the new coating something to bite into. On cast iron this is slow, patient work, and it’s where a reglaze job is either made or ruined.
After the prep, I ran fresh caulk, masked the room so nothing got overspray on it, and set up ventilation to move the fumes out and keep the air clear. Then I laid down the bright white finish in even coats.
What rolled out the door was a tub that looked brand new but was still that solid, heavy original underneath — the kind of cast iron you simply can’t buy off a shelf now. The homeowner kept the better tub, skipped the demolition, and paid a fraction of the replacement quote. Done in a day, warrantied, and back in service after a short cure.
A quick word on the money, since it’s what brought this homeowner to me in the first place. The replacement quote they’d been sitting on ran into the thousands once you added the demolition, the new fixture, the plumbing, and the tile work to close everything back up. The reglaze came in at a fraction of that, and instead of a week of a torn-up bathroom and a parade of trades, it was one day of work with everything else in the room left untouched. When the tub is fundamentally sound, that math rarely goes the other way.
Once the finish cured, I walked them through keeping it looking right, which is simple enough: skip the abrasive powders and scouring pads that chew up any surface over time, wipe it down with something gentle, and that’s about it. Treated that way, a freshly reglazed cast iron tub holds its bright, glassy finish for years. They went from planning a tear-out to having what looked like a brand-new tub by that evening, and the original heavy iron was still doing the work underneath.
This is a big part of what I do across Colton and the rest of the area, from Orange County through San Bernardino and Riverside. If you’ve got an old cast iron tub that’s rusted, chipped, or just worn dull, refinishing it is almost always the smarter call than tearing it out. I give honest estimates — if reglazing makes sense for your tub, I’ll tell you, and if for some reason it doesn’t, I’ll tell you that too.
For more information you can check out our Blog or FAQ.
