Welcome to Adamov Reglazing, your trusted partner for bathtub reglazing and cabinet refinishing services in Southern California. We proudly serve residential and commercial clients across multiple locations, helping you revitalize your bathrooms and kitchens with cost-effective, professional solutions.
We just wrapped a fiberglass tub reglazing project in Indio, and this was one of those transformations that really shows why reglazing beats living with a tub that’s seen better days. The main problem here was soap scum built up heavy along the sides, and discoloration that had spread across the whole tub. The homeowner had probably scrubbed it a hundred times, but that’s the thing about fiberglass — once it discolors and dulls like this, no amount of cleaning brings it back. The damage is in the surface itself. The only real fix is to refinish it.
So that’s what we did. We started where every good tub refinishing job starts, with a deep cleaning. I went after all that soap scum on the sides, the grime, the buildup, everything that had collected over the years. But cleaning alone isn’t enough on a job like this. After the surface was clean, I went over the whole tub with a light sanding. That step does two things — it knocks down the slick, glossy top layer of the old fiberglass, and it gives the new coating something to grip onto. A coating sprayed over a smooth, untouched surface won’t bond the way it should. The light sanding is what sets the stage for a finish that actually lasts.
Once the tub was cleaned and sanded and ready, I ran a fresh bead of caulk all the way around the unit. Caulking the perimeter does more than just look clean — it seals the tub up against water. Any gap where the tub meets the wall or the floor is a way in for moisture, and moisture behind a tub is how you end up with bigger problems down the road. New caulk all the way around closes those gaps off and gives the whole unit a tight, finished look before any coating goes down.
Then I masked off the entire bathroom. This part takes time, but it’s not optional. Reglazing throws a fine overspray, and that mist will drift and settle on anything it can reach. So I tape and cover the floor, the ceiling, the walls, every surface outside the tub. I’d rather spend the extra time sealing the room off than leave a haze on someone’s bathroom. When you do it right, the only thing that gets touched is the tub itself, and everything else looks exactly the way it did when I walked in.
With the room sealed off and the surface fully prepped, I sprayed the bright white finish. This is the moment the whole job comes together. The tub went from a dingy, discolored, soap-scummed mess to a smooth, glossy, bright white surface that looked brand new. Honestly, it didn’t just change the tub — it changed the whole bathroom. A bright white tub reflects light and freshens up the entire space around it, and that’s exactly what happened here. The homeowner walked in and could hardly believe it was the same tub.
That’s the part I never get tired of. Fiberglass tub reglazing isn’t complicated when you do every step right, but the difference it makes is huge. You take something the homeowner was embarrassed by and turn it into the cleanest thing in the room, and you do it for a fraction of what tearing it out and replacing it would cost.
This job was in Indio, but we handle fiberglass tub reglazing and tub refinishing all over Riverside, San Bernardino, and Orange County. Whether it’s soap scum, discoloration, chips, or just a dated color, reglazing brings your tub back to life. We give honest estimates and we’ll always tell you straight whether it’s the right call for your bathroom.
For more information you check out our Blog or FAQ.
