Welcome to Adamov Reglazing, your trusted partner for bathtub reglazing and cabinet refinishing services in Southern California. We proudly serve residential and commercial clients across multiple locations, helping you revitalize your bathrooms and kitchens with cost-effective, professional solutions.
Just finished up a fiberglass enclosure reglazing job out in Indian Wells, and it’s the kind of project that shows what this work can actually do for a tired old shower. Fiberglass takes a beating over the years. It fades, it dulls, it picks up chips, and once it cracks, water starts finding its way in. This one had been through it, but nothing we couldn’t bring back.
Like always, we started by pulling the fixtures off. The showerhead, the handles, the trim — everything comes off before I touch the surface. It’s not a step you can skip if you want a clean result. Working around fixtures leaves you with gaps and awkward edges, and the coating never lays down right. With everything off the wall, I had a clean, open surface to work with from top to bottom.
Then came the deep cleaning, which on any fiberglass enclosure refinishing job is where most of the real work happens. Years of soap scum, hard water, body oil, all of it has to come off completely. Fiberglass is smooth, and that’s part of the problem — a coating won’t grab onto a slick, dirty surface. So I scrubbed the whole thing down until it was clean and ready to take a finish. People always think the spraying is the main event, but the truth is the prep is what makes a job last.
This enclosure had a couple of chips and one decent-sized hole punched through the side. That’s the kind of damage you can’t just coat over and hope for the best. So I went in and repaired the chips, filled and rebuilt the hole, and sanded everything back down flush so the surface was solid and level again. By the time I was done, you couldn’t tell where the damage had been. That’s important on fiberglass — a hole left unrepaired only spreads, and once it’s coated over without fixing it properly, it’ll come back.
With the repairs done, I masked off the entire room. Walls, floor, ceiling, anything outside the shower got taped and covered. Reglazing throws a fine overspray that drifts and settles on every surface it can reach, so I seal the room off completely before any product goes down. Then I set up my ventilation to pull the fumes and overspray out of the space and keep the air moving while I work. Those two steps — masking and ventilation — are what separate a clean, professional job from one that leaves a haze on everything in the bathroom.
Once the room was sealed and the air was moving, I sprayed an adhesive primer over the whole surface. This is a step a lot of people don’t know about, but it matters a lot on fiberglass. The primer creates a bond between the surface and the topcoat, so the finish actually grips and stays put instead of peeling down the road. On a slick material like fiberglass, that bonding layer is what gives the job its longevity.
After the primer set up, I laid down the bright white finish. That’s always the satisfying part. The whole tub and shower combination went from a faded, chipped, beat-up enclosure to a smooth, glossy, bright white surface that looked brand new. The customer was thrilled — they could hardly believe it was the same shower they’d been looking at for years.
This one was in Indian Wells, but we do fiberglass enclosure refinishing and tub and shower combination work all over Riverside, San Bernardino, and Orange County. Chips, holes, fading, the wrong color — whatever shape your fiberglass is in, reglazing brings it back for a fraction of what replacement costs. We give honest estimates and we’ll always tell you straight whether it’s worth doing.
For more information you check out our Blog or FAQ.
