Welcome to Adamov Reglazing, your trusted partner for bathtub reglazing and cabinet refinishing services in Southern California. We proudly serve residential and commercial clients across multiple locations, helping you revitalize your bathrooms and kitchens with cost-effective, professional solutions.
Short version: the tub was fine. It just looked terrible.
That’s the situation in a lot of Fontana homes. Fiberglass tubs were the standard install for decades because they’re light and cheap, and they hold up structurally — but the surface dulls and scratches with use, and after enough years the tub goes gray and tired-looking even though there’s nothing actually wrong with it. This one had no cracks, no soft spots, none of the real problems. What it had was a dull, flattened finish and a web of fine scratches from years of scrubbing.
You don’t replace a sound tub over that. You refinish it.
Here’s how a fiberglass tub refinishing job actually goes. The first real step is cleaning, and it’s not a token wipe-down — fiberglass holds onto body oil and soap film, and a new coating will not bond over that residue, so I strip the surface completely. Then comes the sanding, which does double duty: it scuffs the slick surface so the coating can grip, and it knocks down the light scratches so they don’t ghost through the finish. The couple of deeper marks got filled first and leveled off so the surface was uniform before anything went on top.
Only after the surface is clean, scuffed, and smooth do I move to the finish. I caulk fresh, mask the room so overspray stays off the walls and fixtures, run ventilation to keep the air clear, and spray the bright white in even coats. The whole thing is wrapped in a day.
The payoff is immediate and a little dramatic — a gray, scratched, worn-out tub comes back glossy and bright white, and a dim bathroom suddenly reads clean and fresh. And the new surface is easier to keep that way: it’s smooth and sealed, so it wipes clean instead of fighting you. The one thing I tell every homeowner is to lay off the harsh abrasive cleaners and scouring pads, because those wear on any finish over time. Stick with something gentle and it holds its shine for years.
It’s worth being clear about what a real refinish is, because the word gets used loosely. This isn’t paint brushed over a tub. It’s a bonded coating that goes down over a properly stripped, sanded, and primed surface, which is why it holds up to daily use instead of peeling at the edges the way a quick paint job does. That prep is the unglamorous majority of the work, and it’s the whole reason the finish lasts.
Practically, the job runs in a single day, and after a short cure the tub is back in service — I’ll tell you exactly how long to give it so the coating sets up hard. It’s warrantied, too, so you’re not gambling on the result. For a Fontana family that just wants their bathroom to look clean and bright again without losing it for a week to a remodel, that’s an easy trade: one day, a sound tub made to look new, and a surface that wipes clean and keeps its shine for years.
If you’re on the fence about whether your tub is worth saving, send me a few photos and I’ll give you a straight read on it, no obligation. Most fiberglass tubs that aren’t cracked are good candidates, and the work is backed by a four-year warranty, so you’re not rolling the dice on the result. I’m glad to show you before-and-after shots from other Fontana-area jobs so you can see exactly what to expect before you commit to anything.
I handle bathtub refinishing across Fontana and out through the Inland Empire, along with Orange County, San Bernardino, and Riverside. If your fiberglass tub has gone dull or picked up scratches, it’s almost certainly a refinish, not a replacement. I’ll give you an honest estimate either way — if it’s not worth doing, I’ll say so.
For more information you can check out our Blog or FAQ.
